1 Inch Fan with AAA Battery Pack

1" 3AAA -
2" Diagonally
1.5" Each side
3/4" Thick

All of these include the fan and the battery kit all wired/hooked up and ready to go. The battery packs have an on/off switch directly on them; toggle fans come with a separate toggle switch so you have an external on/off method.

1" Fans will fit in all of our resin blanks except for snarly and fox, which only fits the 7/8" fan; the others will not.

This fan runs off a lower voltage so takes 3AAA batteries. 

For toggle switch fans, the length you choose will be halved to make the full length. So if you choose 24" wire, you'll have 12" to the toggle switch, and 12" to the battery pack from the toggle switch. 

All electronics are tested before they're mailed out, and given a small stress test. Please let us know if you receive a fan that isn't working even after using new batteries, and making sure all packs are switched to the ON. Remember for toggle switch fans you'll have to turn both switches on for the fan to work. :D

Normally for installation you would install the jawset, and then install the fan on top of the jawset behind the nose, pulling air from the nose holes and blowing it into your face. However there are some who prefer to have the fan blowing out of the nose instead; it's really personal preference! Remember fans will add some noise (they are electronic, after all!) but they do make a world of difference in how long you can wear your suit comfortably.